Welding method

Home / Technical / Welding method
Cut the Oxy Plus Combi pipe vertical to the axis using pipe scissors.
Place the Oxy Plus Combi pipe inside the face smoothing tool. Do not forget that cutting the face vertical to the axis is not always possible with pipe scissors. Cutting the face horizontal causes problems during the welding process. Face smoothing tool is an elegant, well-designed engineering product that will solve this problem. Face smoothing tool has to be used.
Smoothen the face of the pipe using the face smoothing tool and make sure that a channel is opened in the part covered with folio. The face should be smoothened until the whole face surface touches the bottom of the face smoothing tool. Dizayn Group does not guarantee installations made without using face smoothening tool.
Oxy Combi Plus pipe with its face smoothened.
Push the Oxy Plus Combi pipe and its fitting vertically towards the special welding screw plate at the same time. The special welding screw plate was designed to prevent possible mistakes by installation workers.
After you see that the melted material comes through the holes on the special welding screw plate, remove the pipe and its fitting from the screw plate. (When you look at the face removed from the screw plate, you will see that the aluminium folio in the middle is inside the plastic). Special welding screw plate should certainly be used while welding Oxy Plus Combi pipes.
Connect the pipe and fitting you removed from the screw plate immediately. Do not turn the pipe and fitting while connecting.
Our company guarantees installation made connecting Dizayn pipe with Dizayn fittings and complying with the defined rules.
Welding Method for PPR pipes and fitting
Check wheather the welding machine is heated up to 260°C, the thermostat lamb went off and the screw plates are clean.
Cut the pipe vertical to its axis using pipe scissors. Check whether the pipe and fitting are clean and dry or not. If needed, clean the pipe and fittings with dry fabric.
Push the pipe and the fitting vertically towards the special welding screw plate at the same time.
Remark: Connect Dizayn Sanitary PPR pipes only with Dizayn Sanitary PPR fittings. Our company guarantee installations made connecting Dizayn Pipes with Dizayn Fittings and complying with the defined rules.
Unitl you see that the melted material comes through the holes on the special welding screw plate, heat the pipe and fitting in the screw plate. Special Welding Screw Plate must certainly be used while welding Dizayn PPR Sanitary Pipes.
Do not turn the pipe or fitting during welding or connecting.
Connect the pipe and the fitting immediately after removing from the screw plate.